Eno
Eno interactive boards integrate digital pens with whiteboard markers for a full multimedia experience. They use no wires or cords, are magnetic, dry erase, interactive, and virtually indestructible.
Unlike a SMART Board, Eno is not activated by touch. There is a control strip along the side, which you can select with the Eno pen, to change the Eno pen settings (as explained below).
Turn on & use Eno
Log into the podium computer and turn on the projector.
Remove the Eno pen cap, to turn it on.
Plug the bluetooth connection device into an available port on either the computer tower or the side of the monitor.
Tap projection mode icon on the control strip.
Orient Eno
Align the projected image with the Eno board
When the projected image fits within the whiteboard frame, use the Eno pen to tap the projection mode icon on the control strip once.
Re-calibrate the projected image on the Eno board
If the cursor or writing on the board appears off by a few pixels, re-calibrate it.
Select the bottom button in the control strip twice to get the green calibration screen.
Note: The green screen & calibrate circles come up every time the board starts and Fix Projector should be Enabled.
Select Disable.
Select the bottom button in the control strip twice to get the green calibration screen.
Adjust until the Eno pen and cursor are corrected.
Select Enable.
Verify that the projected image fits within the whiteboard frame.
Tap the projection mode icon on the control strip once.